Operation: *Rear Seat Delete* Part 1...removal of rear seats!!

[Crazzy_Al]

Since I didn't see any articles/tutorials/write-ups on how to do a rear seat removal on a 99-04 Mustang, on this site, I thought I'd write one up. Enjoy...

You will need:

Flat-head Screwdriver
15mm Open-Ended Wrench
10mm Socket
8mm Socket
1/4" Drive Rachet
A little bit of patience



Step 1:

Find your back seat...



Ahhh, there it is. (yes, the indentations on my seat backs are front my seat belts...I always have the seat backs down...to cool the amplifiers)

Step 2:

Locate the tabs at the top of the floor board and below the seat lip that hold the seat down... (see green arrows)



Step 3:

After you find the tabs, push them in with a screwdriver and lift the rear seat up... (see green arrows)




Step 4:

Remove the tabs. You will need an 8mm socket and a 1/4" drive socket to do this... (this will alow your rear seat delete kit to fit flush with the carpet when it's installed)



Step 5:

Remove seat backs. You will need a 15mm Open-Ended wrench to do this... (in order to access these bolts **outside only** you will need to pull the leather away at the far bottom left **passenger's side** seat and far bottom right **driver's side** seat.)