sbc in mustang
 

does any one make a good kit really interested in this i have a motor and possibly a car? any thing i should look out for? any help would help thanks!

The easiest way to do it is to get a motor plate, a set of headers made, a crossmember, and a custom oil pan. It's been done plenty of times.. I'd ask Todd (pacecarbbc) from Reiters, he's done quite a few of them.

If you dont want to run plates, you can do it with a k-member from AJE. Kooks sells headers also. But Chevrolet Mustangs are slow.

thanks the only reason i was considering it was i have a motor and got a line on a roller.

I was just kidding about them being slow :)

they look factory sitting in a mustang!:D

We sell a SBC into a fox and 96-04, The K member works with Dyno tech swap headers, we sell those also!

how much for the headers? and how much for the k-member?do you make a trans crossmember?if you do how much ?

$289 for the K member and $700 for the headers

did u have any clearance issues with the hood what size cowl do you run and also any idea what doing this does to resale value?

well resale it will dbl cause it will have a chevy in it! lol


i have a 4" hood on mine and it is tight i only have a 1/2" to spare no air cleaner! i will proably will be going to a 6" this winter cause you should at least have 3/4" clearance!

>:P

:lol: :lol: :lol:

Sorry the headers are $489!

thank u they r slow its a waste of time